Alignment Pump and Motor Training Program

Alignment Pump and Motor Training Program – Motor-Pump alignment is the process of aligning shaft centerlines between a motor and a pump. The motor is the prime mover, transferring power to the pump by the use of a coupling. This is probably the most common configuration of coupled machines in industry. In this type of alignment, the motor is almost always the moveable machine, and the pump is the stationary machine. In almost all cases, the pump is already piped up with suction and discharge flanges, which means it can move only slightly, if at all.

Proper shaft alignment is achieved by moving the motor. It is shimmed vertically to achieve the proper elevation to align it to the pump, both parallel (offset) and angular. The motor is them moved horizontally to achieve proper horizontal placement for aligning the shaft centerlines, both parallel and angular. The motor is moved horizontally by the use of jacking bolts, or by the use of pry bars, hammers, or other tools.

Motors are normally easier to move, since the motor is not piped into a process system. A short run of flexible conduit is most often used to run the electrical wiring from a local disconnect, or a rigid conduit, to the motor termination box. This allows for ease of movement of the motor. Training-Bagus.com held this Alignment Pump and Motor Training Program to develop skill and competency of your personnel.


INFORMASI DAN PENDAFTARAN
HUBUNGI: FERDI
0812 2681 1987
(PHONE/SMS/WHATSAPP)

Alignment Pump and Motor Training Content

1. Fundamental Alignment
2. Diagnosing Misalignment
3. Measuring Misalignment
4. Preparing Task Alignment
5. Alignment Methods (praktis)

  • Rough Methods
  • Face and Rim

6. Alignment Tolerances
7. Complicating Factor Alignment.
8. Introduction to Laser Alignment
9. Minimizes the forces of misalignment acting upon the bearings and seals of both components.
10. Minimizes Wear of The Coupling.
11. Reduce Energy Costs.
12. Maximizes the life of the Machine Components by Minimizing Wear, ncreasing time between failures, and reducing vibration.

Training Method

  • Presentation
  • Discussion
  • Simulation
  • Case Study
  • Evaluation

Who Should Attend

  • Instrument Engineer/Supervisor, Plant Maintenance/Operators/Supervisors

Time and Venue

  • Silahkan hubungi kami untuk mendapatkan informasi jadwal terbaru
  • Inhouse Training kami laksanakan sesuai request dari perusahaan
  • Untuk Request Pelatihan Online Bisa Menghubungi Kami

Training Cost 

  • Rp. 6.500.000/participant/non-residential
  • Rp. 5.700.000/participant/minimum 3 participants from the same company

Training Facilities

  • Training Handout
  • Flash disk
  • Certificate
  • Exclusive Souvenir
  • Qualified Bag
  • Training Photo
  • Training room with full AC facilities and multimedia
  • Once lunch and twice coffee break every day of training
  • Qualified Instructor
  • Transportation from airport / railway to hotel and from hotel to the training venue (2 person from one company)

INFORMASI DAN PENDAFTARAN
HUBUNGI: FERDI
0812 2681 1987
(PHONE/SMS/WHATSAPP)

image source: https://pivotalpumps.com/articles/what-is-shaft-alignment/

Mungkin Anda Menyukai

Tinggalkan Balasan

Alamat email Anda tidak akan dipublikasikan.